Setup guide

How to stop the Tesla FSD nag in under two minutes

FSD Buddy needs no tools, no wiring and no firmware. Follow these five steps and the cabin camera sees an attentive driver from the moment you pull away.

Step-by-step installation

  1. 1. Locate the cabin camera

    Find the interior camera in the headliner above the rearview mirror, next to the SOS button.

  2. 2. Clean the mounting area

    Wipe the headliner beside the camera with the included alcohol pad and let it dry.

  3. 3. Attach the magnetic puck

    Peel the backing and press the low-profile puck firmly to the headliner for 30 seconds.

  4. 4. Snap on the Buddy and aim it

    Attach the head to the magnet and rotate it so the face points forward, inside the camera's view.

  5. 5. Verify in the camera preview

    Open Controls > Service > Camera Preview and confirm the face is visible and well lit.

Troubleshooting

  • Still nagging at night? Angle the face slightly toward the driver's seat so ambient light reaches it.
  • Head drifting? Re-seat it on the magnet and confirm the puck is fully bonded to the headliner.
  • Can't see it in preview? Move the puck 1–2 cm closer to the mirror stalk.

Stay legal and stay safe

FSD is a supervised system. FSD Buddy is a novelty dashboard accessory — keep your eyes on the road, hands ready on the wheel, and follow the rules where you drive.

Frequently asked questions

How long does installation take?

About a minute. Peel the puck backing, press it to the headliner beside the camera, and snap the Buddy onto the magnet.

Will it fall off in the heat?

The adhesive puck is rated for cabin temperatures and the head is magnetically retained, so it stays put on rough roads and in summer heat.

Can I remove it for service visits?

Yes — the head lifts off the magnet in one motion and the puck peels away without residue.

What if it doesn't work for my car?

Return it within 30 days for a full refund. A 90-day replacement warranty covers defects.